How to install solar street lights
Solar lights, is now the most widely used lighting roads we use, to our travel at night to provide a very good help, that our solar street light installation step is how it? Today to introduce solar street lighting installation methods and procedures for your understanding.

Solar Street Light Installation
Solar street light installation – Foundation pouring

Ascertaining the position of the lamp; geological prospecting, if the surface is 1 m 2 are soft soil, the depth of the excavation should be deepened; the same time to confirm the location of the excavation the following no other facilities (such as cables, pipes, etc.), the top of the street no longer shade object, or to the appropriate replacement position. In the location of the lamp stand aside (excavation) standard 1 m3 pit; be positioned to be buried pouring. Embedded parts placed in a square hole in the middle, PVC pipe threading one end of the embedded parts in the middle, on the other end of the battery storage.

Keep the embedded parts, the original foundation and the ground at the same level (or screw top with the original ground at the same level, according to the site needs), there should be parallel with the side of the road; this can only be assured after the erection of poles and correct not skewed. Then fixed with C20 concrete pouring, pouring process either disable vibrator vibration, ensure the overall compactness, robustness. Construction is completed, clean the positioning plate residual sludge, waste oil and clean the bolt impurities. Concrete solidification process, to regularly water conservation; concrete to be completely solidified (usually more than 72 hours) to be installed chandeliers.

Solar street light installation – installation of a solar cell module

The output of the solar panel positive and negative measures shall be taken before connecting the controller to avoid short circuit; solar cell module is connected to the stand solid and reliable; output should avoid bare wire assembly, with tie pitched; toward the battery assembly to be heading south to the compass points to prevail.

Solar street light installation – Battery Installation

When the battery is placed in the control box to be gently, to prevent smashed the control box; cables between the battery must be bolted pressure on the battery terminals and copper pads to enhance the conductivity; output line connected to the battery after the ban under any circumstances short, to avoid damage to the battery; to be through PVC pipe threading controller battery output line and poles inside the linked; after the completion of the above, check the wiring on the controller side to prevent short circuits. After normal shut the door of the control box.

Solar street light installation – lighting installation

That various parts of the fixed components: solar panels fixed on the solar panel bracket, lamp fixed to the pick arm bracket and then pick arm is fixed to the main lever and threading the cable to the control box (battery box). Before lifting pole, check whether all parts of fasteners firmly lamp installation is correct, whether the source is working properly. Then whether simple debugging system is working properly; loosen the solar panels on the controller cable, light work; cable connect solar panels, lights out; carefully observe changes in the controller for each indicator; everything is normal before lifting installation. The main pole lifting, attention to safety precautions; fastening screws absolute good, such as the angle of the sun assembly deviate need to end up fully adjust its orientation toward the sun due south.

The battery into the battery case, in accordance with the technical requirements of the cable connected to the controller; first of battery, connect the load, and then take solar panels; the wiring operation must pay attention to the brightest and the controller on the terminal marked terminals can not be connected wrong, positive and negative polarities can not crash, can not be reversed; otherwise the controller will be damaged. Whether debug system is working properly; loosen the solar panels on the controller cable, lights; at the same time connected to the solar panel cables, lights out; carefully observe the changes on the controller for each indicator; everything is normal, before the seal control box.

Above is to introduce about some of the ways solar street light installation step, and only through the correct installation of our solar street lights get it to work and use, in order to provide us with a bright at night time, but it also requires specialized staff to carry out the installation.